Installation Videos
We realized installation videos are a lot better than a user manual so please enjoy these detailed videos to get your bike assembled and tuned.
Does your derailleur cable appear to be on the inside of the frame not the outside? Your bike was not routed incorrectly. It actually has to do with the way the chain was unraveled. Please follow this video to revert the derailleur to the correct side.
Thru-Axle Conversion Kit Installation
*Special Note: The front caliper on the thru-axle fork has an adaptor that connect to the brake itself. You will want to undo those 2 bolts, flip over the adaptor, and reinstall. This allows the caliper to clear the rotor correctly when the thru-axle fork is installed.
Allen Keys needed for each bolt on the X
- Four bolts on the stem to clamp handlebars- 4mm (torqued to rougly 5nm)
- Two bolts that attach to the steerer tube of the fork- 5mm (torqued to rougly 5nm)
- Seatpost collar- 5mm (torqued to rougly 5nm)
- Saddle rails clamp- 6mm
- Derailleur hanger- 3mm
- Attachment for the derailleur to the hanger- 5mm
- Derailleur cable pinch bolt- 4mm
- Pedals to crankarms- 15mm wrench. Rotate toward the front wheel to tighten. (Right pedal clockwise tighten, Left pedal counter-clockwise tighten). Hand thread until the very end and give final torque with the wrench. The warranty does not cover stripped crank arms.
- Crank arm bolt that connects to bottom bracket spindle- 8mm
- Brake caliper bolts that connect to frame and fork- 4mm
- Brake pad adjusters- 3mm
- Brake cable pinch bolt- 5mm
X Ambition Installation Dropbar and Flatbar (box with wheels next to bike).
Norton Hardtail MTB Installation
Allen Keys needed for each bolt on the Redwood
- Four bolts on the stem to clamp handlebars- 4mm (torqued to rougly 5nm)
- Two bolts that attach to the steerer tube of the fork- 4mm (torqued to rougly 5nm)
- Seatpost collar- 5mm (torqued to rougly 5nm)
- Saddle rails clamp- 6mm
- Derailleur hanger- 2.5mm
- Attachment for the derailleur to the hanger- 5mm
- Derailleur cable pinch bolt- 4mm
- Pedals to crankarms- 15mm wrench. Rotate toward the front wheel to tighten. (Right pedal clockwise tighten, Left pedal counter-clockwise tighten). Hand thread until the very end and give final torque with the wrench. The warranty does not cover stripped crank arms.
- Crank arm bolt that connects to bottom bracket spindle- 8mm
- Brake caliper bolts that connect to frame and fork- 4mm
- Brake pad adjusters- 3mm
- Brake cable pinch bolt- 5mm
- Bolt-on thru axles- 6mm
Redwood Installation Dropbar and Flatbar (box with wheels next to bike).
Longer Box with rear wheel attached for Redwood installation
Sprout Balance Bike Installation
Sapling Mountain Bike Installation